I replaced a side brush motor on my Eufy Robovac 11s. The new motor works fine, but now the system can not locate its charging base. If I put it close to the base and tell it to dock from the remote control, it pivots from side to side like it is searching for a signal, but it never connects correctly with the charging base. I cleaned the dust from all surfaces, but it did not help.
There must be something wrong with the infra red sensor.
I dont think that issue is caused by the motor swapping.
My suggestio is to clean sensor
When mine can’t find the base its usually dust or something blocking the sensor. Give it a quick clean and try it again. Also might want to wipe down the dock. Use a dry cloth and don’t wet the cloth or the unit. I’ve had to do that. If that doesn’t work contact support.
I have the same exact problem after replacing my brush motor! Purchased an official one from the eufy website. It seems to work really well now, but it struggles really bad locating the charging dock now!
Did you clean all the front sensors properly?
I would take off the bumper again and take a look if there is everything placed perfectly.
Yeah, yesterday I took the entire bumper off again completely, cleaned all the sensors, and reattached everything. The bumper moves freely also, as it’s supposed to do. I even referenced a video online, showing all the cable attachments to the motherboard inside to verify I did that correctly also. Not sure what else to do, but eufy 11S is cleaning my floors nicely, it still can’t find home on its own
Ok, seems you have all done what could be done.
I suppose to place the charging station at another place, will not help as well.
I am sure it has nothing to do with your replacement of the motor
if cables are correctly plugged in the sockets.
Have you sprayed contact spray at the sockets and the plugs.
That’s all which comes in my mind at last.
Sorry no more ideas.
May be others have new ones at the EUFY-forum where you could publish your inquiry